I am trying to line this stamp set up with the Stamparatus. I have no problem with lining up the two pieces of the large medallion. I thought since I had the medallion centered on a 4" square of paper and had it in the corner of the Stamparatus, that I could then line up the small circle piece with one of the points on the medallion and rotate the paper 1/4 and the small circle would line up with each point. I found that it was close, but slightly off. I measured the large medallion and maybe it is less than 1/16" off center, but I would not expect my customers to be any more exact than that!
Has anyone played with this? It's pretty, but if you have to be exact to 1/16 of an inch, I'm not sure I will demo it.